Photo's from 3.5" exhaust Avant

[V6quattro]

Hy.

I'm ordering parts for a complete 3.5" exhaust system for my S2 Avant. I already have 2 SIMONS 3.5" silencer. But it would be nice to see some photo's off complete systems for ordering the rest off the parts. I already had some nice photo's off a B5Q 3.5" one but i can't find them any more

I's not possible for my to put the car on a lift before ordering

Tanks.

[hermanio]

rs4 b5 3.5 inch

[s2_bo]

Just one box That must me loud!

[Jamo]

What bhp are you planning on running for a full 3.5"?

I've heard a full 3.5" and it's bloody loud!

[V6quattro]

Tanx for the pix Herman!

@ jamo, How much silencers did it had? I'm planing to run 2 and i will put the end tip down to reduce the noise a little bit more.
Thees are the muffles i have

http://www.turbozentrum.de/abgassystem/schalldaempfer/89mm-daempfer/simons-grand-89mm/a-1325/

http://www.turbozentrum.de/abgassystem/schalldaempfer/89mm-daempfer/simons-grandotight-89mm/a-1731/

Hope to run around 600 crank.

[Jamo]

2 silencers, really does make a difference the pipe size. will be a sweet free flowing exhaust though

600 crank can be done on large bore downpipe and 3" back doesn't have to be 3.5 to make that power.

[Ian Simmonds]

That'll be fine, trust me, I'm running a three inch single box with no cats on the 20vT rallycar and it meets a lot of uk circuits 98db... Far better than the old engine in it, that was 109db...

[Thuppu]

I'm planing to run 2 and i will put the end tip down to reduce the noise a little bit more.
Thees are the muffles i have

http://www.turbozentrum.de/abgassystem/schalldaempfer/89mm-daempfer/simons-grand-89mm/a-1325/

http://www.turbozentrum.de/abgassystem/schalldaempfer/89mm-daempfer/simons-grandotight-89mm/a-1731/

Wow, you have copied my plan! I have the exact same silencers and was also thinking of putting the end tip down. Are you using any cat? My plan is to do the exhaust like this: Turbo with 3" outlet, reducer to 4" -> 4" DP -> 5" 100cell cat -> 4" flex -> 4" ~1m pipe -> reducer to 3,5" pipe with mufflers to the rear. WG with a separat 2" pipe and muffler, flow to atmosphere.

[V6quattro]

No i don't use a cat. I don't need one for the AKP (the Dutch MOT). And i will make a 3.5" downpipe. Not sure about the wast-gate (MV-R) yet. I think i will put it in the exhaust after the downpipe.

[quattrostyle]

No i don't use a cat. I don't need one for the APK (Dutch MOT).

typo

[V6quattro]

And now