Main project thread is here http://www.s2forum.com/forum/showthr...=23127&page=13
The question I have is in the project thread but since not everyone is interested in it....
when I was fitting the dash in, to get the centre part to move in at the right height and line up completely I had to remove the driver's side bracket that should hold the back of the glovebox (driver's side of the glovebox that is). This fitted perfectly in the old car with the smaller heater/blower unit but the new car has A/C and therefore is a bit bulkier.


The bracket on the other side still fits but is right up against the blower casing

Any thoughts on this anyone? I assume i'll not be able to get the glovebox on now.
cheers
The question I have is in the project thread but since not everyone is interested in it....
when I was fitting the dash in, to get the centre part to move in at the right height and line up completely I had to remove the driver's side bracket that should hold the back of the glovebox (driver's side of the glovebox that is). This fitted perfectly in the old car with the smaller heater/blower unit but the new car has A/C and therefore is a bit bulkier.


The bracket on the other side still fits but is right up against the blower casing

Any thoughts on this anyone? I assume i'll not be able to get the glovebox on now.
cheers

(that purple leathered TT knob is hideous isn't it
)




Comment