Dan, I've done this myself in the past. I can't really offer much in the way of tips or advice. All I did was use feed the bolt in using the allen key and move it around slightly until it aligned with the clamp.
Oh and you might find that you are not getting the bolt to thread because you are turning the it clockwise which in effect is counter clockwise since the bolt is inverted.
I've certainly made this mistake before at any rate.
HTH.
Oh and you might find that you are not getting the bolt to thread because you are turning the it clockwise which in effect is counter clockwise since the bolt is inverted.
I've certainly made this mistake before at any rate.
HTH.
Comment