My shopping list is nearly sorted for all the mounts and bushes i will need. I have on my list Powerflex Wishbone bushes all round, Powerflex ARB bushes, Alloy Subframe bushes, 034 Track Density Engine, Rear Diff and Transmission mounts. Have i missed anything else off?
-
3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips
(just need the RS2 Airbox) -
Sounds good - decent topmounts wouldn't hurt either IMO
If you're gonna go the whole hog i'd look at new bal joints and track rod ends tooPanthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 AvantComment
-
Put new blue top mounts on there which i know are not the most highly rated on here. Do u know rough cost of ball joints and track rods?3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips (just need the RS2 Airbox)Comment
-
Febi are probably your best bet for balljoints if you don't want to pay dealer prices..... maybe try Pete at QC?
IIRC fronts are quite reasonable, rears are morePanthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 AvantComment
-
sent pete an email see how much they are. might put new wishbones on to.3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips (just need the RS2 Airbox)Comment
-
I got front ball joints for the avant and they were only £25 each for pressed arms from Pete(check me out on telly)Reeve's
,i think cast arm ball joints are £35 each. I have just been looking at all the torque setting for when i do mine. I've got poly bushes front and rear new RS2 strut top mounts and a set of H&R's to fit. Can't wait to get them all fitted this month
Just some finishing touches to do nowComment
Comment