subframe poli bushes dimensions

[ACQ]

Maybe someone has dimensions of polyurethane/aluminium bushes for front and rear subframes? car is audi coupe quattro typ85.

[_ShurikeN]

There's a well known sketch:

Your center holes should be 10 instead of 12.

[ACQ]

many thanks. 12mm to the subframe hole length? looks like it must be longer, but if you made bushes by this drawing and they fit so I will trust

[_ShurikeN]

10mm and 12mm are center hole diameters for subframe bolts: early and later versions depending on cars.
Actually, I can't confirm anything yet. I did not have such bushes made personally for me by this sketch, but I have bought ready set made of steel. I can measure my washers.

[ACQ]

I didn't mean center hole, but place where is 6mm lenght in drawing

[_ShurikeN]

Ok, I see. Unfortunately I don't have the exact inner height of subframe hole. I might have some rubber bushings to measure. But It may be faster if you buy а cheap rubber bushing for yourself.

Btw, i have had a look at my metal washers yesterday night. They are quite the same as on pictures except outer diameter being 48 not 50. Affects nothing actually.

[ACQ]

Still looking for dimmensions