Sre clutch and 7a is this right?

[Costash]

In the middle of fitting clutch pp and disc and is should be a gap between flywheel and clutch assembly like in picture?

[John.]

Something's wrong there. Wrong disc perhaps?.........assuming you've tightened the bolts up!?

[Kiku]

7A flywheel, 3B disc(SRE or AAN disc works aswell) and 707 SRE.

[Costash]

Something's wrong there. Wrong disc perhaps?.........assuming you've tightened the bolts up!?

No thats before tightened them up. I though the pp should touch the flywheel before you tight in the bolts?

[Costash]

7A flywheel, 3B disc(SRE or AAN disc works aswell) and 707 SRE.

I have all the above

[Costash]

https://www.sachsperformance.com/en/...-quattro-162kw

this is what I have

[rxl]

clutch disk upside down?

[piotr]

Defo not looking right,the locating pins on flywheel are miles away from pressure plate.one of the parts is incorrect I think

[Costash]

clutch disk upside down?

Is facing the flat side to flywheel which is ok

[Costash]

I tightening the bolts up and pp is close to flywheel but my question is : the pp suppose to go straight on top of flywheel like touching or like on the picture is needed to tighten the bolts for the pp to touch the flywheel.

[Error404]

Pressure plate needs to mate up against the flywheel, but only when bolts are tight and diaphragm is tensioned. Otherwise the clutch will slip as there is no clamping force.

[AndyP]

I tightening the bolts up and pp is close to flywheel but my question is : the pp suppose to go straight on top of flywheel like touching or like on the picture is needed to tighten the bolts for the pp to touch the flywheel.

No, you'll need to tighten the bolts, BUT I'm pretty certain mine went onto the dowels, yours looks like its a way off?

[Tom_]

Guys, i join to this thread (if its OK) I Have 7A clutch on stroker 2.5 20V (AAT) what disc clutch and cover clutch u recommend for around 800Nm. Any experience or part numbers?

[Costash]

No, you'll need to tighten the bolts, BUT I'm pretty certain mine went onto the dowels, yours looks like its a way off?

It did go like 2 mill on the dowel. ..

[Costash]

Guys, i join to this thread (if its OK) I Have 7A clutch on stroker 2.5 20V (AAT) what disc clutch and cover clutch u recommend for around 800Nm. Any experience or part numbers?

I think sre can handle 800nm but not for allot of drag like occasionally