You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
Linked timing chart worked for me. If timing is wrong torsen did not turn.
Washers I used were AS3552 (Old torsen). just relpaced the bronze and needle bearings at the ends. two piece and new B5 E and F torsens use AS3047. https://www.dropbox.com/sh/h6jnswfiq...4OPEC-1Xa?dl=0
Unfortuantly the picture didn't work anymore.
I have this type of diff (attached picture) and as far as I understood I have to replace one needle bearing and the bronze washer with this AS3552 correct?
Can somebody confirm me this? Thanks in advance!
You do not have permission to view this gallery.
This gallery has 1 photos.
You have PM. Bronze and needle bearings are bad You need to maintain original thicknesses in place. You can use AS/LS3552 thrus plates and the ones you have in original needle bearings
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
You need to maintain original thicknesses in place. You can use AS/LS3552 thrus plates and the ones you have in original needle bearings
Comment