i hace just replaced the clutch master following the squeak and snap common to aby
i used a crappy ecp part that wasn't quite right on the threads. i managed to get it to work until i have a proper one but after bleeding the clutch with the pressure bleeder i now get good flow of fluid but the pedal drops and then has around w2 inch of pressure like they are when the piston bends.
any ideas on this.
the piston on the master looks to move nice and straight and it had a good bleed.
does the screw on bit have to be set in a certain position when fitting to the pedal?
could it be a slave or clutch problem
cheers in advance
i used a crappy ecp part that wasn't quite right on the threads. i managed to get it to work until i have a proper one but after bleeding the clutch with the pressure bleeder i now get good flow of fluid but the pedal drops and then has around w2 inch of pressure like they are when the piston bends.
any ideas on this.
the piston on the master looks to move nice and straight and it had a good bleed.
does the screw on bit have to be set in a certain position when fitting to the pedal?
could it be a slave or clutch problem
cheers in advance
Comment