Tweet
Guys,
What's the best place who can make custom driveshafts?
thx
What's the best place who can make custom driveshafts?
thx
-
-
http://www.fixittransmission.com
Available here for S2-RS2-S4: http://webshop.cp-service.se/en/135-drivaxlar
Perhaps a group buy? -
Also it can be made in Hungary , dont know the price exactly but the axle itself seems to be strong
http://www.youtube.com/watch?v=5SYh0...g9A&playnext=1
it uses some axles, from them, also i use the same, it holded till now.Comment
-
-
Don't think a group buy would suffice. My shafts are a mix of S2 and UR. On the other hand, I think I can manage with a mix of 4 front S2 shafts....Originally posted by quattro84 View PostComment
-
So does this mean you are running an 82mm bearing in the rear to fit front S2 shafts? I'm looking into possibly doing this to allow running 4 of the same axles on my build...with some spacers at the output flange on the long corners.Originally posted by Jeffer View PostComment
-
over here in the USA, i have had great experience with A1-CVTech out of Canada....
holds my ~900BHP and low 9 sec 1/4 miles with some pretty hard launches just fine. 1.400 60' time is best on slicks.
and i shattered a rear diff once but not the axles.
Comment
-
Indeed it's identical front and rear. Thats because its a Sport Quattro setup. The hubs, bearings, housings are Sport Quattro. The CV joints are audi 100, with the nut on the outside, instead of the bolt. Audi S2/UR/CQ rear shafts fit in that.Comment
-
Any one know price for that driveshafts?I need to
Comment
-
dss.com they prices were not bad at allDD 1990 CQT 800+HP SOLD
1/4 mile 10.70@135.66
(SOLD)
http://www.youtube.com/watch?v=Yy-YlssmSfY
http://www.youtube.com/watch?v=8XgzVJyvrfg
2003 A6 4.2 Quattro
97 MB S320 DDComment
-
How much is " not bad"?Originally posted by Jeffer View Post
RED Mitsubishi Lancer Evolution VI TME nº 16 of 250
BLACK Mitsubishi Lancer Evolution VI TME nº 189 of 250
LWB Audi Sport Quattro projectComment
Comment