6 speed gearbox from urs4 and aby

[K7ERG]

What are the differences between these 2 gearboxes? What is required to fit say a urs4 6 speed gearbox into a 3b s2?

Thanks in advance

[Rocco]

01e gearbox mounts,and coupe aby short propshaft mainly. Linkage is optional but better if he find one from 01e .

[AndyD]

01e gearbox mounts,and coupe aby short propshaft mainly. Linkage is optional but better if he find one from 01e .

So you would need ABY gearbox mounts and propshaft and preferably the ABY linkage to make it all fit, is that right?

[Rocco]

Yes and gearbox spacer

[AndyD]

Yes and gearbox spacer

Sorry for my ignorance but where is the gearbox spacer for?

[Rusty]

It's used on B4 cars with a dual mass flywheel, as the DM FW is thicker than the older style single mass item.

[Rocco]

Also better to use V6 or 01e front subframes

[Val]

Yes and gearbox spacer

hm, now I understand why my mounts are too close to engine. How thick is this spacer?

[Jonas_R]

My list:

Aby coupe propshaft or aby avant front part of propshaft paired with rear 3b.
Aby coupe/avant gearbox mounts and 2x 10-15mm spacer or v6 subframe
6 Speed linkage.

You dont need the gearbox spacer.

[Error404]

you will need the linkage or you will need to custom make one - a 5 speed linkage is completely different

[AndyP]

you will need the linkage or you will need to custom make one - a 5 speed linkage is completely different

I had to fit an ABY linkage when I did the gearbox conversion

[Jonas_R]

Is the linkage the two arms on the gearbox that controls the gearshift?

Then yes you need that as well.

What do you call the part the goes from the linkage to the gearshift arm in the car?