So it it the same thickness as a 3b? I don't want to fit it and end up with a horribly low or high pedal!!
-
-
Someone did mention a longer push rod on the slave cylinder but I don't think
this is needed in this case, unless the push rod is shorter than the one used on an ABY set up.
They way to be sure is measure from the flywheel location face to the springs
on the pressure plate where the release bearing presses.
Do this on both assemblies i.e. flywheel, friction plate and pressure plate bolted together.
I think you will find they are the same, if not then the only other thing is the longer push rod
as was mentioned.
Comment
-
I take it you haven't seen this: http://forums.quattroworld.com/s4s6/msgs/24612.phtml
It might be cheaper/easier to source a 7A flywheel than a 3B to be honest.Comment
Comment