Gear box flange bolts Etka

[terrybullwon]

I need two of the flange bolts that fit the gear box drive flanges.

Now my problem.

I ordered a set of these

N 0447141 and they were just cap heads at 5x times the price they should be.

i am thinking i need these..... 088409359 any one can confirm this?

Part number 15

[terrybullwon]

These

[A1quattro]

bolts

think rear diff bolts are the same ,5 speed boxs also they dont need doing up realy tight /old ones are fine

[terrybullwon]

Old ones are the problem, need a new set

[terrybullwon]

Rear diff bolts make sense thanks Ray

[Error404]

I have one of these, brand new

[terrybullwon]

Still got the part number on the bag Alex?

[malncol]

they are the tappered seat type. I had the flanges machined a little to remove the tapper, then you can run normal bolts (correct length) much easier to get
mal

[terrybullwon]

they are the tappered seat type. I had the flanges machined a little to remove the tapper, then you can run normal bolts (correct length) much easier to get
mal

So your using a doudty washer or a copper washer to control the oil?

[Error404]

I'll have a look a bit later mate

[malncol]

So your using a doudty washer or a copper washer to control the oil?

good point, hadnt thought of that, locite/sealant on the thread??
mal

[piotr]

Not sure if old/second hand bolts for that will be ok as im 99%sure they are stretch bolts.

[Toph]

So your using a doudty washer or a copper washer to control the oil?

good point, hadnt thought of that, locite/sealant on the thread??
mal

Here in the States, we had both types of heads - tapered like in your photo, chef, as well as flat. The 01E that is now in my CQ came with the flat seat, but the 100mm cups that I swapped in from a 4000(type85) 016 had the tapered seat. I didn't notice any special sealing washer when I removed the flat seat bolts. I still have the 108mm cups that came from my 01E with the flat seat. I can check on the part number if you're interested, or even send them over to you if they can't be found over there. Hope that helps.

[malncol]

now that you metion it ,i have some of each here and i dont see any seal arrangement,
while we are at it anyone know the correct nm/ft for that bolt as there is not a get deal of meat in the washer it goes in (number 23 in pic)

[Mikes2]

088 409 359 is a stretch bolt - 10Nm + 90 degrees. quite high for an M8