Audi urs4 2.2 clutch kit

[MattP]

Hi guys

I need a new clutch kit but i don't know where to buy it....on ebay i don't find anything (probably wrong search terms but good)

S4 1992 6speed manual.

The car is stock but i prefer a stronger clutch for a long life time and there will probably some chip upgrade in the future.

Links to the
Sachs and luk kits are welcome!

**How long does it take to replace it because i am not going to this job myself. (if you guys say 1dag and the garage says 3days i know someone it trying to get money out of my pockets)

[UrS4boy]

On my side of the pond, UrS people have been happy with Southbend clutch kits sold by Marc S. at EFI Express:

http://www.efiexpress.com/catalog/pr...products_id=24

Here is some C4 UrS clutch info that I put together some time ago. Spec is not popular anymore. But Southbend still is. Note: LUK was the OE supplier. The LUK replacement kit should be " 02-025 ". But confirm this yourself.

http://forums.quattroworld.com/s4s6/msgs/24719.phtml

[OLD100]

I am no expert but did a lot of research when I needed one and I went too 034 and got a spec stage 5 clutch and billet aluminium flywheel :-) good points you cannot break it bad points it is very noisy and viciously sharp not good for road use but I would go with stage 3 for road use and would recommend flywheel if there is no budget

[MattP]

Thanks UrS4boy nice explanation!
But anyone has links where i can buy a set in Europe?
And i forgot to mention is a stage 2 or 3 clutch better and a long lifer if i tow some weight on the trailer (1500kg or more kg)?

[UrS4boy]

Thanks UrS4boy nice explanation!
But anyone has links where i can buy a set in Europe?

The first one in this ebay.de search is what you need.

http://www.ebay.de/sch/i.html?_odkw=...%2FS4&_sacat=0

This site has pressure plates and discs, separately.

http://www.onlinecarparts.co.uk/car-...utch-disc.html

The UrS4/S6 clutch disc is unsprung (because of the dual mass flywheel) and looks like this one from Sachs (from the website above):

[MattP]

Again @urs4boy for the links and the info!

I think i ll go for a standard sash clutch kit though
- 3000 951 052
- 3000 951 053 (i also came across this one witch is 70eur cheaper then 52)
What is the difference between those 2?


And while the box is open i might as well replace the
- release bearing 01E141165B
-Slave cylinder (can't find the part number for the 5cyl??)
- Master cylinder is not needed i guess unless leaking? Part number?

[s2foruvgtpe]

Your steps are correct, although, you can save a step by not removing the chrome. If you scuff all the chrome good enough, you won't have any adhesion problems. You also don't have to wet sand, Oferta silnikowa: PB silniki benzynowe, ON silniki diesla.https://autowikius.com/. W nawiasie kod silnika, czyli np. PB 2.0 (LF) oznacza silnik benzynowy o pojemności 2.0 i kodzie fabrycznym LF.,you can dry sand it just fine. You don't have to sand in between coats unless there are defects or something gets in the paint.