AAN lightweight Flywheel.

[popdemonic]

looking to upgrade my Dual Mass Flywheel.I have found
Fidanza Part#122211 and 034 offered a 12lbs version for AAN with
stock clutch application.Anyone ever had any experiences on those
Flywheel?

http://store.034motorsport.com/flywh...s4-s6-aan.html

http://www.ebay.com/itm/Fidanza-1122...-/380823377044

[caterpillar]

havent tryed alu flywheel, but a steel singelmass stage 3+ .. and 6 pucket sinter with spring in the senterhub...it was great...

[le mans]

I've been running a Fidanza flywheel with stock clutch in my B5 RS4 for 6 years or so. It's proven reliable and if you like a more free revving engine it's a good choice. Downside is less engine inertia which makes it a little tricky when driving slowly (have to change up quickly to avoid dropping the revs too far and losing momentum). Also get chatter below 1800 rpm if trying to accelerate/go up hill but only in 2nd and 3rd as a rule.

[Thuppu]

I run Fidanza alu-wheel with Sachs SRE and 4-puch sinter.

[mushasho!]

I'm also looking for a single mass AAN replacement. It doesn't need to be light weight and could even be steel construction.

Is the Sachs SRE the same as a 707 or 765 Thuppu?

Sent from my SM-N910F using Tapatalk

[Thuppu]

Sorry, missed this. I'm using SRE 754.

[s0_big]

Running with leanders clutch flywheel and damped 4-puck sinter clutch. No problems, like it a lot

[orignalS60]

The best quality I've found at the best price point
is TTV flywheels. They can even make you custom
spec stuff. A true single mass steel design as well
with absolutely nothing bolted or riveted on.

TTVracing.com. They're in the UK.

[Thuppu]

Billet steel flywheels have been available for years.

For 707 clutch: http://www.blingfactory.fi/epages/vi...cts%2FBF200103

For 754 clutch: http://www.blingfactory.fi/epages/vi...ducts/BF200104

For 7.5" clutch: http://www.blingfactory.fi/epages/vi...ducts/BF200101

[orignalS60]

Yes I'm aware of that but most still have
the ****** riveted on tone ring. When going
for big power/ high revs etc. I prefer a true
1 piece unit. That leaves nothing to fail or
break on it. Also the TTV flywheels are better
quality and cheaper than %90 of flywheels on
the market. Also Thomas on audizine in the b5
section their was a thread started for people
using the fidanza flywheel and the tone ring
falling off and ruining their clutch & tranny
bell housing. It's ****** design they have bolted
on friction surfaces and riveted on tone ring.