You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
Before i put the engine in the car i was thinking abouth using my k24 7000
Will it have any benefit?
Maybe someone done something similar or done maping for this set up?Will injector get maxed out and the fuel pump?
P.S. its 140hp stock engine
Last edited by Majorcina; 25 November 2014, 21:34.
You can fit the K24 comp wheel and housing on the K14 CHRA, I looked at doing this on mine. Decided against it in the end as it wasn't going to do what I was looking for, which is more bottom end, like a VNT turbo.
Should give you a solid 200bhp turbo if that's that you're looking for
sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racer
Worth doing as will give you a slightly higher flowing compressor wheel which with the lager hotside, 6cm rather 3cm will give more flow potential. Just need figure out a waste gate.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment