Announcement

Collapse
No announcement yet.

Full set of RS2 lower door trims needs restoring

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Full set of RS2 lower door trims needs restoring

    Full set of lower door trims need new metal strips installed I put new metal strips in my own set worked realy well.

    Full set £100 not including shipping

  • #2
    Where did you get the metal strips made up mate? I have the same problem with my car, I guess any metal workshop could fabricate them.
    1992 C4 100 2.8 Avant quattro, daily driver.
    1989 B3 2.0 (for now) quattro.
    1996 C4 2.8 30V quattro.
    1990 3B Offically dead.
    1995 RS2, MTM K26/7, 340 BHP conversion. Wrapped in cotton wool.

    Comment


    • #3
      I had a friend of mine fabricate them for me I have a couple of strips left not enough to do a whole car but they are easy to fabricate. My problem was removing the existing corroded metal i needed up using brute force (wood chisel and patience) heat the rubber to get the metal out and a shot blaster to clean the the rest of the rust from the rubber strips. I then used a high strength silicon to bond in the new strips then off to the paint shop. I do have 3 decent rubber strips for sale that need re metalling

      Comment


      • #4
        Right... Nice one for the advice, I have a metal workshop close by with the equipment to fabricate the strips, just need to recover a strip with right profile on from the knackered sections on my doors.
        1992 C4 100 2.8 Avant quattro, daily driver.
        1989 B3 2.0 (for now) quattro.
        1996 C4 2.8 30V quattro.
        1990 3B Offically dead.
        1995 RS2, MTM K26/7, 340 BHP conversion. Wrapped in cotton wool.

        Comment


        • #5
          just take care when removing the existing metal I managed to rip a hole through one of the strips tease it out use a bit of heat even a cutting disc to get the metal out

          Comment

          Working...
          X