3B Aircon System

[lini]

I'm pretty sure there is a separate sub-loom for the aircon that is optional fitment. I'll have to check up on that with zee good books !

Paul

The KL15, ligting, diagnose and couple more is conected in the midle of a main loom. But anyway you can steal a signal here an there.

[Jon441cc]

I found that quite easy to get at.

Good man. Have you found an alternative place for the battery? I haven't quite decided yet, other than NOT under the bonnet.

Anywhere i like

http://shop.edoperformance.co.uk/braille-carbon-fiber-race-battery-p-9358.html

[Jon441cc]

Would have liked too get a few more pictures but i just wanted to get this done.

Thier are four 10mm nuts holding the heater box in :

Two on the bulkhead, where the two black sealing washers are:


And another two where the air feed for the fan is, underneath this run off shroud

Could'nt be bothered to take it back off after i had fitted back correctly to stop any water run off from the windscreen pooling in the footwell

Hole in the bulkhead where the air con pipes come through:


Pipe running from Condensor to pump:


Pipe running from bukhead to pump:

Really easy to get too when you take the wing off

Everything else is pretty self explanitory.
After weighing all the parts of the air con system it all came in at 18.1kg, not including the air con matrix in the heater box, the pump alone weighed in at 10.7kg condensor was 5kg and the lines brackets and bolts came in at 2.4kg.

I have a spare ABY radiator fan and thought i would weigh it, 4.8kg

[4WheelDrifter]

Anywhere i like

http://shop.edoperformance.co.uk/bra...ry-p-9358.html

Nice.

[johne]

could you fit the digital climate control to a RHD, non air-con car i wonder? :mischeif:

I'm in the process of doing it using the climate control system from an A4. I posted some details a while back in response to a similar question under the "heating" section.

[johne]

Mounted automatic aircon to my previous coupe. ......... and you have to make a big hole in a firewall if there was no AC original.

Photos of instalation can be found here:

See page 5!

In my case I found that the firewall was already "scored" in the right place and one hit from the inside with a cold chisel where the aircon pipes go through left a nice oval hole in the right place.

[Acidburn]

I've just removed a heater unit and tbh they are not too bad if you know where all the bolts etc are, it was a bit of trial and guesswork (no errors allowed as the heatermatrix is spoken for) and it was out, documented it in the other thread I did, glad to see you got your car a bit lighter tho.