Audi S2 Coupe Rebuild "Silver Spiken"

[Eriksson]

Yes, only @ the rear end of Silver Spiken

Will be Replacing my oxygen Sensor tomorrow, and the "NEW" Tappets Are ready

[zlobo]

nice work

[Eriksson]

Now i have some updates.
one day, when it can't happen stressed and mutch at work.
Parked in the city turn the key and nothing happens, lights and everything turns on and the ignition feelt a bit strange.
Luckely Prosty the savior and "Bäst på allt" helped me push start it and drove to the garage. ignition cylinder was broaken.

Im posting a guide how to replace ignition cylinder and keep same "original" keys.



Also i have changed back to my renewd tappets, it sounds better, no tick tick.
When replasing the tappets i mounted a 7A Exhaust cam to se if theres any diffrance between my original 3b "special" longer duration and 7A cam. inlet is still the same.

Tnx S2Andreas.

i will test the car tomorrow and mayby me and prosty will do a few Gtec runs.
Mayby some movies.

Best Regards Per Eriksson

[Andreas]

I hope it does as well as you think it will! When are you g-teching? I'm working until 17:30-17:45...

[zlobo]

i had the same issue a while ago..

[Eriksson]

Hehe Zlobo, it has broaken exactly the same way!

Luckely the problem was fixet quite easily
But not the funniest thing tu put my money on.

[prosty]

Gtech runs sounds great. I can drive both cars so you have an indicator of how fast it CAN go, not how fast you can go with it.

[Braun]

Hi Eriksson!Congratulate your car,very beautiful!I would have a question to you!H&R I would like to buy a spring.Which one do you use?You would be able to grant it H&R in a catalogue a character's number?Thank you.

Braun

[Eriksson]

Hi, and tank you.

i found a picture of the front ones,


the rear part nr im not sure of, i know it starts with HA

[Eriksson]

This is what im doing right now with the car.
Repainting the Sills again.

Found some Scooby snacks under the list.
Uset heater gun to remove them. i have alredy replaced them a while ago.


All cleaned up


POR15 i really good !

[Braun]

Thanks.I try to look it up based on the code!

[Eriksson]

Been a while since i posted some updates, but there has been some new RTM modifications done to the car.

AAN intake, RTM cross member and new BIG intercooler.
Also 7A intake and Exhaust cams with catcams adjustable cam gear.

To do,
Olicooler
EX mainfold
Clutch
Turbo
Stainless Exhaust
Fuel Pump

Will post pictures later tonight.

[dkw_dude]

Hi, how did your car respond to these changes? If you have driven it afterwards. I have a set of 7A cams on the shelf, and I am thinking about changing the inlet manifold to a "front facing" type to reduce piping and the number of bends in the intake system.

Been a while since i posted some updates, but there has been some new RTM modifications done to the car.

AAN intake, RTM cross member and new BIG intercooler.
Also 7A intake and Exhaust cams with catcams adjustable cam gear.

[Eriksson]

the car runs really good now, and more top end power.
Also with the new intercooler and intake i dont notice if its hot outside.

All things are possitive

[Andreas]

And you learned to weld as good as any! you must show some pics cause it looks awesome!