Project: Engine Build for beginners.

[Error404]

you can't build engines whilst wearing a snorkle?

Pft! Amateur

[Flat on my back]

I hear a dish washer works wonders

Are you going to do any porting at all?

Cheers James

Hoping to match the intakes and exhausts to the manifolds (RS2 em still to arrive) and match the flow in all chambers.

Still to source valves (oversize?) and book an appointment with my engine tuner, says 2008 is already booked?

Putting together a full list of parts and costs,eg nuts, bolts and gaskets etc.

And just bought a mostly straight b4 v6q for the s2'erization to start, so money is rapidly dwindling!!!

James, any flow results or still looking for an uncracked head?

[dubmeister]

I hear a dish washer works wonders

They work amazingly well!!!!

Head will come out gleaming- do it with all your other ally parts while the wife/girlfriend/mother is out shopping , then once finished chuck some plates, coffee mugs etc.. in and put it on the full wash- with a bit of luck you will not get found out and be in the good books for doing the washing up!!!!!!!!!:mischeif: :mischeif:

[Flat on my back]

Yeh...just need one! No more room in the kitchen...not that i go there very often...'cept to get beer from the fridge!

[dubmeister]

.........Or if you are scared of a womans fury................
http://cgi.ebay.co.uk/AEG-OKO-Favori...QQcmdZViewItem

[spink]

I tryed getting a cylinder head in mine the other day but its not big enough ,the rotor thing gets in the way.

[Flat on my back]

Hmmmmmm...could fit it under the workbench in the garage and then plumb it in...now what do i need?

[dubmeister]

Hmmmmmm...could fit it under the workbench in the garage and then plumb it in...now what do i need?

Good man............try this..............

http://www.diyfixit.com/diy/plumbing/machine_install/machine_install.html

[Flat on my back]

Hope you do divorce negotiations cos i'm gonna need it at this rate!

[Flat on my back]

I tryed getting a cylinder head in mine the other day but its not big enough ,the rotor thing gets in the way.

Try harder...i need to know?

[Flat on my back]

A little more progress...

Had a good number of parts cleaned...trial build to see what else is needed.

[Flat on my back]

Plus...started on the bottom end...

Ooooooo...so clean...

[Flat on my back]

and the other side...

here...

[Flat on my back]

And best...

the inside...

[Flat on my back]

Hoping to get this fitted...

.