Each end is a new beginning.

[lind4hl]

all the welds that is automatic welded looks like this, nothing to worry about

[Error404]

you will need to use a sleeve joint in the middle by the look of it Rok so I think the slight difference in length is not a problem
Is it 2.5" / 63mm pipe?

[spyros80]

Very nice! I look forward to seeing it on the car

[Skull]

you will need to use a sleeve joint in the middle by the look of it Rok so I think the slight difference in length is not a problem
Is it 2.5" / 63mm pipe?

i got the joint (50€), but...

ah, wasting words, i go fit it.

[Skull]

It doesent fit

[Error404]

Too short? Can you weld in a longer sleeve section?

[Skull]

it is not to short, but the pre owners did some modifications to the cat. i will sort that out no problem.

the second problem is that the brackets are not high enough, or the "S" rear bumper is that much lower compared to the stock audi 80 bumper.

anyway, 1 1/2 inch too high.





set in the wrong hole and with the bolts loose sits perfectly.



i will buy longer bolts and use some spacers, i dont have the patience to cut and reweld the brackets on the muffler

[A80Avant]

thats a perfect fit!!

[Error404]

Looks lovely
Can't you just weld a sleeve over the hanger, so it is the right size for the lower hole?

[irishs2]

Really looking forward to your feedback on the Fox.. nice work looks very good.

[Skull]

it doesent look so bad...

[spyros80]

Nice fit Skull! The pipes of the muffler should be a little bit longer but it looks like ok to me. What about the sound? What are the differences from the original muffler?

[Error404]

perfect fit IMHO

[Skull]

I recorded the sound:

Youtube Video

Now it sounds like a 5 cylinder 20v engine that got one cylinder chopped off

[Andreas]

You are correct, it does not look bad.. it looks AWESOME <: