project ur quattro OEM+

[robbie100hp]

I asked the guys to make a step on the top tank so i can retain the original cover of an oem look, the technicians at GDM were worried about the air flow through the rad with the original fan motor and rear cowl so close to the water bottles in the engine bay, so they made a custom rear cowl and race fan which has made loads of room behind the rad to allow the air to flow, they also made the lower scoop to aid flow.
Just to note the rad core is 80mm.

[jsws3]

Nice addition the scoop I wounder what cowboys car you seen that on ����

[robbie100hp]

I had nothing to do with the design, they just did it off there own back honist

[jsws3]

Looks nice mate I think I'll end up putting a bigger rad in again

[Az786]

What did all that costs if your willing to share?!

[fish]

Looks nice, except the scoop.. Dont like stuff stickning out under cars. I understand why its there though so fair enough. To get a bit more OEM look maybe paint the top portion of the rad and maybe even the scoop satin black or wrinkel paint flat black? It would make the radiator top melt in a bit better IMO.

[robbie100hp]

Looks nice, except the scoop.. Dont like stuff stickning out under cars. I understand why its there though so fair enough. To get a bit more OEM look maybe paint the top portion of the rad and maybe even the scoop satin black or wrinkel paint flat black? It would make the radiator top melt in a bit better IMO.

I agree with all the above, you cant see the scoop unless you get right down so its not that bad. I will be painting it all satin black when i strip it down for the new engine setup but this is still in development. As for the scoop maybe something like rubber guard or something a bit tougher against the stones ect.

As for price give Darren a call at GDM on 01889 574880

I think you maybe pleasantly surprised!

[robbie100hp]

Say hello to my little friend!

[newsh]

Biiiiiiiiig turbo [emoji15]

[LeafBox]

That is awesome