MPXH6300 PCB Question

[S2central.net]

Has anybody ever found a source for a small PCB that accommodates these 3bar MAP sensors - with a 3-pin header/connector that can easily be soldered onto ECU board ?
I always hated soldering the wee blighters inside the ECU and my eyesight is only getting worse these days. Would be an easy project for someone with PCB s/w and means to make small batch...

[diesel des]

I know a fella up the road from you that has PCB prototype kit, Inc a wee CNC mill for pcbs.

Sent from my Moto G (5) using Tapatalk

[S2central.net]

That man Ivan ???

[diesel des]

Nope Ian. Will text you a number.

Sent from my Moto G (5) using Tapatalk

[diesel des]

Ah pm me your number I have managed to loose yours...

Sent from my Moto G (5) using Tapatalk

[prj]

Just design a board using any CAD software... The only thing that is a bit tricky is the 2.54mm spacing double angled connector. Not sure if it exists.
Could try to find a 3-row right angled ribbon and a normal right angled connector, then combine the two, should be quite sturdy i'd imagine.

[blux]

There are plenty PCB vendors online for making one according to your design. Or just take some prototype PCB bord and place it on there.

[S2central.net]

Yeah I was looking at software such as "circuit wizard" or similar.

[prj]

Diptrace, eaglecad.

[Nuno_Cristiano]

I have here some this PCB´s done myself.

[S2central.net]

God I love this place !

@Nuno - can I pls buy a handful of these bare PCBs from you ?

[Nuno_Cristiano]

Hello,

How much you need?

Actually i have 6 in stock.

Later i can do more PCB´s.