Hi guys,done the pin swap to use an aby ecu with 3b loom,was looking for some info with regards to pins 47,48 and 49.
Having researched both 3b and aby pin assignments some of the terminology is confusing me slightly.
I've got for the 3b loom;
47 engine speed sensor
48 reference point for engine speed &CPS 49 CPS
For the aby I have;
47 crank reference (62 degrees btdc on cylinder 1)
48 0v reference for crank sensors
49 crank speed sensor
I've not swapped any pins yet,it's confusing me a little tbh
Also the car is a TDI converted to petrol tank etc,I previously had the fuel pump on its own relay controlled by a standalone ecu.
Obviously now I'm using motronic,my question is where on the fuse board do I take the pump 12 v feed from?
Any help would be greatly appreciated as I'm so close to getting her running,cheers
Having researched both 3b and aby pin assignments some of the terminology is confusing me slightly.
I've got for the 3b loom;
47 engine speed sensor
48 reference point for engine speed &CPS 49 CPS
For the aby I have;
47 crank reference (62 degrees btdc on cylinder 1)
48 0v reference for crank sensors
49 crank speed sensor
I've not swapped any pins yet,it's confusing me a little tbh
Also the car is a TDI converted to petrol tank etc,I previously had the fuel pump on its own relay controlled by a standalone ecu.
Obviously now I'm using motronic,my question is where on the fuse board do I take the pump 12 v feed from?
Any help would be greatly appreciated as I'm so close to getting her running,cheers
Comment