You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
I've just done my 10v this afternoon, the studs are loctited and just go in to the end of the thread, and get nipped up.
The torque is for the nuts which should have special thick washers (they do on the ur anyway..)
Are you using new studs? and nuts? I was told to fit new studs but I could re-use the nuts if in good nick, just bang them with a hammer to rejuvenate the locking effect, in the end I used new nuts too...
25Nm isn't very tight, the ur (10v) is 35 and no probs (only has 10 studs though).
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment