7a block stroker

[mac2226]

I’m thinking of building stroker short block from a spare 7a block I have in garage. I’m using 95.5mm crank also it’s going to be turbo not n/a power would like people who have done this what rod to pistons you went for

[A80Avant]

FCP engineering has a set they can order for you.
I plan to do the same but with smaller pistons

[mac2226]

I’ve asked fcp already but not had a answer on rod length to use

[AndyP]

I don't think FCP make a piston for this combination of parts, I think you're going to need a 144mm rod with a custom piston.

[A80Avant]

I was told that is need 144mm with custom pistons they have the spec for. Difference is the piston size which they can order as well

[mac2226]

I don't think FCP make a piston for this combination of parts, I think you're going to need a 144mm rod with a custom piston.

Hi Andy fcp said they use 144mm rod with a custom je piston they get

[mac2226]

I was told that is need 144mm with custom pistons they have the spec for. Difference is the piston size which they can order as well

Yes same here

[Error404]

Jonus has a kit for the 220mm short block.

[A80Avant]

I have requested a set of pistons that has the 4032 T6 alloy that expands less. I don't like oil consumption. Hopefully they can make one

[mac2226]

Jonus has a kit for the 220mm short block.

Yes he does I’m hopeing to get to look at a set very soon thanks Alex

[mac2226]

I have requested a set of pistons that has the 4032 T6 alloy that expands less. I don't like oil consumption. Hopefully they can make one

Are they je pistons?

[A80Avant]

Yes JE can make that alloy too

Sent from my SM-P550 using Tapatalk

[RaikAAAA]

I have unicorn crank for that kind of setup, 92.8mm
Then u can use 144mm rod and cheap supra or tfsi piston, also positive ise u have less stress on engine, better piston speed and rod/stroke ratio.
Crank is original, have whole abt c5 coupe engine

[A80Avant]

What's the best comp ratio to go for , for such an engine. Boost no.more than 2bar

[mac2226]

What's the best comp ratio to go for , for such an engine. Boost no.more than 2bar

The pistons I’ve been told to use are 8.5 comp