I am interested in upgrading a 3B to 2.5L. does anyone know which block to use for this task.
-
-
Are you really in the USA? I have one for sale if you're interested?sigpic
1991 Audi S2 3B - 2.5 Stroker engine
1997 A6 2.5TDi quattro avant - C4
1976 RD250E / 350LC cafe racer -
Are you going for a tall deck stroker with a diesel crank? If so, I'd stick with an AEL or AAT.
If you're going for over bored pistons, basically any block you can find domestically should do the part.2013 Touareg TDI /// #farmenwagen
1992 80q 20v /// Eventual AAN'd Winter Sled
1990 Cq /// Project: Because RacecarComment
-
What is the AEL or AAT?Comment
-
Hi. Im done it. Indigence what system are you want to leave. Im using 60-2 on the flywheel and vems combination . what i need to upgrade on the block just blanket the hole for the engine breeder.
If original system. need make the space for the sensors.Comment
-
I'm about to pull the trigger on a eruovan bottom end. But then again, I'm one of the few weirdos left trying to build 10vt power...Comment
Comment