You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
Honda CBR 1100XX Blackbird Turbo....undergoing major changes.....
S2 Coupe... bit easier off the line...
'03 ZX12-R daily hack.... lots of nice bolt ons...
Head studs to block : fingertight
Head nuts : 90nm, don't use the small washers provided by arp. Get bigger ones. Re-torque after first run. These instructions are from finnish Audi forum from member Repo.
Main studs: if the thread pitch is the same as oem use oem torque. Otherwise use the torque provided by main studs supplier. If the thread pitch is finer than oem and you torque them to oem spec, the main caps won't be round anymore.
Yes im worry obout roundnes ot the main caps,now all of them are 0.03mm when its tight with original bolts ?did i nee to make rehone of the main tunel?
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Im runing into little doubt regarding the proper torque spec of mains and head studs from ARP!
Comment