rs2 parts on homefried s2

[valjo]

hi!

i have audi s2 aby with homefries. i wonder what will happend if i put rs2 ehoust mainfold and downpipe to original s2 setup. will ecu adopt to new hardware?
what about lag etc?

thanks

[lind4hl]

i think you not will gain so much extra hp on rs2 exhaust, why not an 3" directly and a remap? it will work without a remap, but to get the last bhp you will need it.

[valjo]

because i will go for rs2 tehnic but in the middle time i wonder if i could use parts i allready have at home

[lind4hl]

the car will work with rs2 exhaust without remap, that´s for sure

[Jonas_R]

If you are going to run a RS2 turbo as well, then I would wait with the installation of the downpipe and EM.

It takes quite a lot of hours to change the turbo, so why not do downpipe, turbo and EM at once?

[DarrenM]

Im running RS2 turbo and 3"DP & system on a homefry, was gonna wait till i get the injectors & IC before getting it mapped witha 3bar v-map tho. It is laggy but just needs winding up. I'll pull my finger out and get the other bits one day.

[Rusty]

I'm running homefries with RS2 IC, 3" turbo back, samcos, modified airbox. Runs fine when I've had it tested on rolling road. Hoping to keep pushing the Homefries for a while yet too. It ran better with 3" than OE, RS2 IC wasn't such a big change but that's being worked on.