Hi there guys.
I'm new to this site and looking for some advice please.
Currently looking to start an 90 quattro s2 engine conversion. Want it to be a budget daily hack/ occasional track tool. looking for around 400hp. Been advised the usual route to 400bhp is rs2 exhaust manifold, k26 hybrid or gt30, good exhaust, good intercooler, big injectors and fuel pump and remap.
I was thinking of supercharging the S2 lump. Done a bit of research into this yesterday and found a Jag XKR charger. Runs at 12psi and pulley upgrade 15psi max due to charger temp. Anyone any ideas? Apart from fabrication issues, i think it would be a good project. Good ol ebay!
Let me know your thoughts/ issues with this?
HP Loss due to timing adjustment: 0
Est. flywheel HP with supercharger: 465.5085
Est. rear wheel HP with supercharger: 372.4068
Total HP Gain: 235.5085 flywheel HP
Percentage Gain: 102.395 %
Many thanks.
James
I'm new to this site and looking for some advice please.
Currently looking to start an 90 quattro s2 engine conversion. Want it to be a budget daily hack/ occasional track tool. looking for around 400hp. Been advised the usual route to 400bhp is rs2 exhaust manifold, k26 hybrid or gt30, good exhaust, good intercooler, big injectors and fuel pump and remap.
I was thinking of supercharging the S2 lump. Done a bit of research into this yesterday and found a Jag XKR charger. Runs at 12psi and pulley upgrade 15psi max due to charger temp. Anyone any ideas? Apart from fabrication issues, i think it would be a good project. Good ol ebay!
Let me know your thoughts/ issues with this?
HP Loss due to timing adjustment: 0
Est. flywheel HP with supercharger: 465.5085
Est. rear wheel HP with supercharger: 372.4068
Total HP Gain: 235.5085 flywheel HP
Percentage Gain: 102.395 %
Many thanks.
James
from what ive looked into it the jag charger will be the M90? or M112 cant remember which but this is a massive charger built for cc of 4litre and above
ive got the M62 from a 2.3 merc and it would flow almost the correct rate for the 5pot to make around 1bar of boost from very low rpm all of the above are eaton chargers. i did look into others such as lysholm and screw style chargers but they are difficult to find second hand and expensive (especially the lysholm style the same as what goes on merc slr's:mischeif
Comment