Homefry RS2 Setup boost?

[stevieyid]

So a 3'' downpipe thenis a must if im going to get the best of the map and the set up?

[lind4hl]

Im sure my dump valve is a recirc valve, could this be the problem?

mine were OEM recirc valve also, typo, sorry

[Jamo]

I have a 3'' cat back system with no cats but standard downpipe

ahaha! so it's been limited so your running about 300-310 bhp then

[stevieyid]

I have a 3'' cat back system with no cats but standard downpipe

[A80Avant]

yes correction i meant vaccum

the figures i was referring to were on idle. ON afterrun mine also goes to 0.8-0.9 vaccum

[stevieyid]

my Dumpvalve was very atmosperic, i had 0.9bar max on standard ecu

Im sure my dump valve is a recirc valve, could this be the problem?

[Jamo]

MRC chip the RS2 to 1.9 bar. If you have full 3" system and RS2 setup your car is nowhere near full potential

[lind4hl]

yeah goes to 1.3 bar and then tails off to 1 bar. Not very aggressive then. Done a boost leak test and that did not show any leaks in the boost hoses. The PCV system was leaking though

my Dumpvalve was very atmosperic, i had 0.9bar max on standard ecu

[stevieyid]

yeah goes to 1.3 bar and then tails off to 1 bar. Not very aggressive then. Done a boost leak test and that did not show any leaks in the boost hoses. The PCV system was leaking though

[Jamo]

RS2 homefry going to 1.3?

It goes to 1.4 or 1.5 stock RS2 ecu AFAIK

[lind4hl]

on idle it should be around 0.4 to 0.5bar.

you have a boost leak. check your hoses

eeh, what? you say an rs2 have 0.4bar on idle

-0.4 i would say!

[A80Avant]

on idle it should be around 0.4 to 0.5bar.

you have a boost leak. check your hoses

[stevieyid]

Be interested to know what boost people are running on the homefry RS2 chips? Im currently getting 1.3 bar tailing off to 1 bar at the red line. Also when driving i see vacume going off the scale which is minus 1 bar on idle its -0.8 bar is this about right?