ABY Crank locking tool - Part No?

[Thuppu]

Here is mine

[defcon]

This is for the NG and 7A : http://www.20v-sauger-tuning.de/zahnriemenwerkzeug.htm

Only the depth (34mm) should be different, I think.

Thanks alot. After some German suche I found this:

http://www.audidrivers.de/pdf/motor_getriebe/Zahnriemenwechsel_AAR.pdf

[Fat Audi 80]

Found this while searching for the 3256 tool -

http://www.audi.co.uk/content/dam/au...ary%202012.pdf

Lists the tools and prices.

Word of warning! The 3256 does NOT fit the ABY with airconditioning. You will need a length of M10 studding and some nuts and washers to space it and secure it....

Cheers,

Steve

[Rusty]

There's only 1 pulley lusted for ABY and ADU so this must apply to all

[Fat Audi 80]

Well it does not fit my car with AC, it could be the sub mount is different with the AC compressor next to it? But in reality, if it fits the way it look like it is designed to the "mounting" face of the spigot on the tool is approx 15 - 20mm too short to fit on the face of the ABY block. I will attach some photos....

[Fat Audi 80]

Pic as promised. Not the best but you can see where I had to remove the bolt, add M10 Studding and insert nuts and washer between the block and the back face of the spigot on the tool... (It also fits into the hole to the LHS which would hold the snub / ac compressor....)

[twoqu]

Thanks to some detective work by Paul N, we now have the definitive VAG answer! Hopefully attached is a extract from the ABY Workshop manual, unfortunately in German, that answers the question once and for all.

[S2central.net]

If I can find time then I will scan in the English paper manual for this !

[MOTORHOOLIGAN]

Its mine, for all engines. I have aby and aan

https://www.s2forum.com/forum/techni...es#post2099520

[MOTORHOOLIGAN]

Here is mine

Good job