Holset HX35 - Flow Chart

[A80Avant]

#8 is 0.57AR so very good EGTs and power then from a really good modified engine i would say.

Hardly though the most representative HX35 numbers i would say..

[Thuppu]

Prj told that he used meth...

[Hammu]

Prj told that he used meth...

True, mulk himself told me that he uses 98oct fuel + methanol injection when i spoke with him @ tatech dynoday.

[quattro84]

The spoolup is fair if 8cm² would equal an A/r of .57
A very likeable torque curve i must say, but i would like the rest of the engine specs. Think it has an uprated WG to overcome the choking if it is this small.

[Thuppu]

Think it has an uprated WG to overcome the choking if it is this small.

Tial V44?

[quattro84]

Ah yes, makes sense. No need for a V60 if looking at the plot.

Thnx Thuppu

[kessu74]

Ok. Do you Rami know if the 670hp dyno plot is available somewhere?

it is in privat forum,i cant show it

[Jamo]

These are the two plots I had don't know if it's the same guy

[kessu74]

different guy but power and torque is almost same

[ian4455]

Daft question but is a HX35 have machined turbine wheel to make it a Super HX35 ?

[Billman]

No, i believe they simply remove the rotating assembly for somethis smaller.

[ian4455]

For the comparisson

-------------------------------Compressor Turbine

KKD Super 35-------------------54/77 55/65
Most common stock HX35-------56/82 60/70
Hybrid HX35/40 Super40--------60/85 60/70

is a common HX35 56/82 60/70 isn't any good for a 20v ?

[Billman]

is a common HX35 56/82 60/70 isn't any good for a 20v ?

It is very good IMHO for this power level according to its dimensions.

[Jamo]

56/60 is near a 3076r which is a 58/60

[Billman]

the GT3076 is a 57/54 turbo (Compressor 57/76mm and turbine 55/60).