I am beging to doubt my sanity right now,with my entire fleet of 3 audis all with problems.
My S6 MOT ran out september 2011
I have been useing the s2 to put some miles on it and run it in for the map to be redone,still got the idle issues and not running to good,dispite lots of work trying to get it right,plus the MOT runs out in 2weeks.
s6 failed on stearing gaiter, track rod end tyre exhaust blowing,rear break disks and pads,hand break ,one tyre with a lump out of the side,and the hand brake,rear drivers side door wont open from inside.
Now my wifes 80 cabby has failed on emmisions,running to rich,and a tye rod.
I have spent ages chasing a missfire problem on this car,and after replacing just about everything[you know how women moan when there cars not right]and adventually trased it down to the fuel filter,which fixed it. Last year I replaced the cats and front pipes etc,every thing on the ignition side is replaced,lamds are a couple of years old tps was replaced.
So I am now completly stumped,because I cannot read the codes,there is no power to the the connectors in the fuse box so cant read the diagnostics
I have a word that I could use right now but I am not allowed.
Any addvise right now would be greatfully appreciated.
My S6 MOT ran out september 2011
I have been useing the s2 to put some miles on it and run it in for the map to be redone,still got the idle issues and not running to good,dispite lots of work trying to get it right,plus the MOT runs out in 2weeks.s6 failed on stearing gaiter, track rod end tyre exhaust blowing,rear break disks and pads,hand break ,one tyre with a lump out of the side,and the hand brake,rear drivers side door wont open from inside.
Now my wifes 80 cabby has failed on emmisions,running to rich,and a tye rod.
I have spent ages chasing a missfire problem on this car,and after replacing just about everything[you know how women moan when there cars not right]and adventually trased it down to the fuel filter,which fixed it. Last year I replaced the cats and front pipes etc,every thing on the ignition side is replaced,lamds are a couple of years old tps was replaced.
So I am now completly stumped,because I cannot read the codes,there is no power to the the connectors in the fuse box so cant read the diagnostics

I have a word that I could use right now but I am not allowed.
Any addvise right now would be greatfully appreciated.


sorted for a car now
Comment