Replace rods on my UrS4..

[Carfreak]

On friday to Sunday I will replace my rods

Just a question, which way should the rods be mounted, I mean which way the grooves for the bearings should go.. I´ve read somewere about this but can´t find the guide..
I also wounder what size the crank pulley bolt has ?


GRRR

[Thuppu]

Here you go: http://www.s2forum.com/forum/showthread.php?t=42878

There is also a really great pic in that thread.

[Carfreak]

Here you go: http://www.s2forum.com/forum/showthread.php?t=42878

There is also a really great pic in that thread.

Awesome, thnx! Hahaha.. but the pic filled it´s purpose

What size does the crank pulley bolt have ?

[aronmatic2]

On friday to Sunday I will replace my rods

Just a question, which way should the rods be mounted, I mean which way the grooves for the bearings should go.. I´ve read somewere about this but can´t find the guide..
I also wounder what size the crank pulley bolt has ?


GRRR

where did you buy the rods?

[Carfreak]

where did you buy the rods?

Everything is bought from cp-service.se
Got a nice price so

[Carfreak]

I will start to rip down the engine tonight Hopefully everything goes as planed.. Can´t be that hard to change the rods

Hmm.. do I need to do something with the oil sludge shield to make room for the ARP 2000 rod bolts ?

[Carfreak]

Soon, very soon I will lift the whole package with im, em and turbo Just need to more hands to help me lift it off

[Carfreak]

Need some help.. can´t remove the oil pan :s It´s stuck between tranny and the pan :s any advice ? I´ve loosen all the hex bolt + the 16mm ones..

[AndyP]

Need some help.. can´t remove the oil pan :s It´s stuck between tranny and the pan :s any advice ? I´ve loosen all the hex bolt + the 16mm ones..

Have you got the 2 bolts that are inside the gearbox bellhousing?

[Carfreak]

Have you got the 2 bolts that are inside the gearbox bellhousing?

I found them and now the pistons and rods are out I will soon reassembly everything with the new h-beam rods!

[Carfreak]

Hmm.. what´s the numbers on STD rod bearings ?? My new bearings says STD but my old ones only has numbers on it..

[Carfreak]

The project moves on this weekend!! New bearings has arrived and some plastiguage!

I must say that my engine is really nice inside.. the only piston that had small ping marks was the 5th one..



No feelable tdc marks in the cyls which is good, also a nice cross hatch pattern and now glazing at all

[Carfreak]

The project is makin progress!! 4 rods and pistons are mounted. Both axial and radial play is measured. 0,050mm radial play and 0,25mm axial.. within specs I hope Downloaded the AAN spec sheet!

[Carfreak]

I hope the radial play is right

[Carfreak]

The job is done and the engine is started! Also found the problem to my rough idle The ISV and After run pump connectors was in wrong place I guess.. the ISV cables are brown and something and the after run is red and white ?

http://www.youtube.com/watch?v=KykwQMBUOKU&feature=youtu.be