s2 turbo etc on a normal 20v

[nik]

bit of a daft question?but could i bolt turbo etc onto my 20v coupe,,,,quattro,?....im guessing they basically the same engine,,,thanks for advice,,,,

[Audicted]

Not an endorsement, but 034motorsports in the US has a bolt on kit for the 7A. NOT cheap.

[WidowmakerS2]

I've seen it done on a 7A, using 3b parts.

Using low pressures controlled by a boost regulator I think he got to low 200hp numbers.

[Cottis]

Buy an S2 and sell me your CQ20v

[nik]

20vq

200bhp...i would guess it around that already,,,,,as its quicker than my ur motored one.....but yep if i could find a budget s2 id buy one,,,,,,wouldnt even mind an s6...

[nik]

Buy an S2 and sell me your CQ20v

...have you seen it pic below if not..

.

http://i1272.photobucket.com/albums/y389/nik19724/3Peaks050_zps69bb972a.jpg

[Cottis]

Ohhh, a white one. Nice. My S2 is my toy but I am always on the lookout for a 20v CQ to replace my daily (Which continues to defy its age but must die soon)

[newsh]

Engine and loom swap from a wrecked S2 is the cheapest and easiest way

[nik]

yep its a great car...out of all the cars i have i drive this one daily..............

[Bowie69]

It's 170BHP as stock.

[nik]

its not stock.....had about..10 ----20v in last ten years,,,7 ur turbo,s ,,various other turbos,,,...so obviously i know what a stock one is like,,,thanks for input tho....,

[Error404]

What mods have you done for ~ 200hp on a 7A?

[nik]

dont hold me to it,,,but ...as far as i know,,,?

stainless exhaust,
manifold(unknown type)
different in jectors?-----think they said volvo?..
performance filter
chip..?

surpossedly had bit head work,,,,not sure what else.........in the past ive been disapointed with 20v,s--------but this one is different...seems well set up...

[WidowmakerS2]

I guess most 7A's without problems seem faster than they are.

Would think you would have to rev it in the mid to high 8000s to get 200hp.

[Bowie69]

Volvo injectors are just part of the 034 upgrade route form a few years back.
Manifold could be the earlier tubular type as opposed to the horrid cast item.
Performance filter = no real gain.
Chips for 7A really just addressed the low end torque problem from my hazy memory, overall power was much the same.

To get 200 from a 7A I would expect you to need a lot more than that, including mechanical stuff such as cams an a fair bit of head work.