More water leaks

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • newsh
    S2Forum Obsessed
    • Aug 2003
    • 16226
    • Country: United Kingdom

    #46
    Raising the windows helped a bit but there is still water getting in down the A pillar. Its actually getting behind the trim piece that carries the seal. So I drilled out the rivets to see what is going on. Here's a pic with the screen trim removed, I'm going to seal the main trim to the body with some new gasket and refit the screen trim with the rubber reglued to it, it was loose. Some dumdum in the top corner to stop the water getting in there. I need the rivets though, not sure what size they're supposed to be..


    S2 Coupe 3B Project


    Ur quattro restoration

    S2 Avant

    Boost is the new rock and roll!
    sigpic

    Comment

    • Christophski
      S2Forum Possessed
      • Mar 2009
      • 3632
      • Country: United Kingdom

      #47
      Hmmm, seems your getting there bud.

      Hope it works.

      Comment

      • andy10v
        S2Forum Zealot
        • Mar 2009
        • 5996
        • Country: Scotland

        #48
        Awesome! I think you have have found my leak as well, its been driving me nuts.

        Keep us updated please.
        Current-2004 Impreza PPP wagon

        Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
        Sold ABY-stock

        Comment

        • AndyP
          S2Forum Zealot
          • Feb 2004
          • 6049
          • Country: England

          #49
          Originally posted by newsh
          Raising the windows helped a bit but there is still water getting in down the A pillar. Its actually getting behind the trim piece that carries the seal. So I drilled out the rivets to see what is going on. Here's a pic with the screen trim removed, I'm going to seal the main trim to the body with some new gasket and refit the screen trim with the rubber reglued to it, it was loose. Some dumdum in the top corner to stop the water getting in there. I need the rivets though, not sure what size they're supposed to be..

          How do you remove the piece of trim that normally covers this area?
          sigpic
          1991 Audi S2 3B - 2.5 Stroker engine
          1997 A6 2.5TDi quattro avant - C4
          1976 RD250E / 350LC cafe racer

          Comment

          • Error404
            Super Moderator
            • Mar 2007
            • 19789
            • Country: United Kingdom

            #50
            peel back the door seal and drill out the rivets, then it slides down and pulls off
            Easier said than done!
            Panthero Coupé quattro 20vt
            Indigo ABY coupé
            Imola B6 S4 Avant

            Comment

            • newsh
              S2Forum Obsessed
              • Aug 2003
              • 16226
              • Country: United Kingdom

              #51
              peel back the door seal and drill out the rivets, then it slides down and pulls off
              Easier said than done!
              Yeah, best to take the seal out and drill all the rivets up the A pillar and the fist one or 2 along the roof line. You can see how much muck the water has dragged in there, a lot of this muck was in between the main seal trim and the bodywork of the roof, meaning the rivets wouldn't pull it up tight, with some gasket and a bit of dumdum all is now looking good.

              In fact its been raining a few times over the last couple of days and there is NO WATER IN THE CAR!!

              S2 Coupe 3B Project


              Ur quattro restoration

              S2 Avant

              Boost is the new rock and roll!
              sigpic

              Comment

              • Christophski
                S2Forum Possessed
                • Mar 2009
                • 3632
                • Country: United Kingdom

                #52
                Nice one bud. Bout time well done!

                Comment

                • S2 EDS
                  S2Forum Maniac
                  • Feb 2011
                  • 578
                  • Country: England

                  #53
                  My little leak.

                  Originally posted by andy10v
                  Awesome! I think you have have found my leak as well, its been driving me nuts.

                  Keep us updated please.
                  I've got a feeling I may have the same problem. Just been out to car after the rain today and the towel I have on the floor is damp again.

                  I thought the issue was the bonner release grommet or the seal around the fuse tray, but these are all good and absolutely no blockages, so no standing water.

                  The water itself seems to trip from off the tray under the steering wheel - the actual side of the footwell - right side is dry and the water travel appears to capillary an inch in from the inner wing (if that makes sense).

                  The problem has been doing my head in - I recently had my Coupe have a new windscreen and watched with interest how the glass technician removed the window, rubber seal and rivets, etc. I too noted how much debris builds up in the a pillar.

                  Not really looking forward to stripping the rubber down, etc, but I know it's a job I've got to do until I can get motor in garage and we are subject to more rain.
                  4 Rings Rule.......Everytime

                  1984 80 Quattro B2 - Project Car
                  1996 S2 - ABY 6 Speed - Pride and joy
                  2003 A2 TDI - Economy

                  Comment

                  • newsh
                    S2Forum Obsessed
                    • Aug 2003
                    • 16226
                    • Country: United Kingdom

                    #54
                    EDS, explain again where you think the water is coming in, it sounds different to mine. Could be the same though, running down the inside of the A pillar interior trim and then running down the side of the dash near the door to drip off the tray into the footwell. The best thing to do is to take some gaffa or masking tape and polythene and tape right over the windscreen trim onto the glass from top to bottom making sure youdon't leave a gap at the top near the roof. Then wait for rain or try a hosepipe and see if it still comes in.

                    S2 Coupe 3B Project


                    Ur quattro restoration

                    S2 Avant

                    Boost is the new rock and roll!
                    sigpic

                    Comment

                    • S2 EDS
                      S2Forum Maniac
                      • Feb 2011
                      • 578
                      • Country: England

                      #55
                      Water Leak further...

                      Originally posted by newsh
                      EDS, explain again where you think the water is coming in, it sounds different to mine. Could be the same though, running down the inside of the A pillar interior trim and then running down the side of the dash near the door to drip off the tray into the footwell. The best thing to do is to take some gaffa or masking tape and polythene and tape right over the windscreen trim onto the glass from top to bottom making sure youdon't leave a gap at the top near the roof. Then wait for rain or try a hosepipe and see if it still comes in.

                      I mean the tray under the steering wheel....about an inch or so in from the right, the water is dripping....very small, but significant over time to soak the towel.

                      I think your advice about taping the windscreen is a good idea....I will try this next...
                      4 Rings Rule.......Everytime

                      1984 80 Quattro B2 - Project Car
                      1996 S2 - ABY 6 Speed - Pride and joy
                      2003 A2 TDI - Economy

                      Comment

                      • andy10v
                        S2Forum Zealot
                        • Mar 2009
                        • 5996
                        • Country: Scotland

                        #56
                        Are special rivets needed? Or will the general purpose ones you get in multipacks do? If special what size are they?
                        Current-2004 Impreza PPP wagon

                        Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
                        Sold ABY-stock

                        Comment

                        • newsh
                          S2Forum Obsessed
                          • Aug 2003
                          • 16226
                          • Country: United Kingdom

                          #57
                          Originally posted by andy10v
                          Are special rivets needed? Or will the general purpose ones you get in multipacks do? If special what size are they?
                          I used the rivets that came with the Ebay rivetting tool I bought, there were 3 sizes I needed and the ones in the kit were perfect.

                          S2 Coupe 3B Project


                          Ur quattro restoration

                          S2 Avant

                          Boost is the new rock and roll!
                          sigpic

                          Comment

                          • andy10v
                            S2Forum Zealot
                            • Mar 2009
                            • 5996
                            • Country: Scotland

                            #58
                            Originally posted by newsh
                            I used the rivets that came with the Ebay rivetting tool I bought, there were 3 sizes I needed and the ones in the kit were perfect.
                            Great, that is exactly what I want to hear, ebay here I come.
                            Current-2004 Impreza PPP wagon

                            Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
                            Sold ABY-stock

                            Comment

                            • QuattroFever
                              S2Forum Extremist
                              • May 2006
                              • 1360
                              • Country: United Kingdom

                              #59
                              Word of warning. Don't know if it was the result of some bad paintwork or just unlucky but I used elec insulation tape to cover the seams on the windscreen trim and when I peeled it off some flakes of lacquer came with it
                              Maybe masking tape or something less sticky is safer.

                              Convinced it's this area now...can hear wind noise getting in from the drivers side on the motorway.
                              Volcano ABY coupe

                              Ant

                              Comment

                              • S2 EDS
                                S2Forum Maniac
                                • Feb 2011
                                • 578
                                • Country: England

                                #60
                                Leak

                                Do you have a sunroof? The rubber seals can go.
                                4 Rings Rule.......Everytime

                                1984 80 Quattro B2 - Project Car
                                1996 S2 - ABY 6 Speed - Pride and joy
                                2003 A2 TDI - Economy

                                Comment

                                Working...