Wastegate pipe wont fit downpipe without serious bending

[Jonas_R]

I'm having some problems with the small wastegate pipe between the downpipe and the wastegate it does not fit without bending the flex pipe a great deal.

I can properly just squeze it on, but I'm afraid that it will ruin the flow.
I have to press the flex pipe downward and that means that the pipe inside the flex pipe wont be pointed straight at the hole in the downpipe but will be offset from the center by 10-20 mm.

Should I worry about this and get a new pipe made or just bolt the sucker on?

[gedu]

Non stock turbo? If so, you are better of by modifying dp or wastegate pipe.

[Jonas_R]

Nah actually it is an RS2 turbo on wagner evo manifold and 034 3" turbo back exhaust system.

However decided to make new wastegate pipe instead, seemed like the easiest options since bending realley did not work that well.