3" Dp?

[adamw]

hi

after a long time thinking about my exhaust and what to do with it, i have settled on a design.

i spoke to a guy about welding up a 3" ss system with 2 boxes... the only problem is he aint keen on makeing a 3" DP?

so im on the look out for a 3" DP with/and separate WG (stock location)

i know a few guys on here can/know someone that can make one... so if you are intreasted give me a shout

[Bubbel]

Iam interested too
Stock Location Rs2 Turbo 3"

[adamw]

anybody?

[lind4hl]

i would need to have an car in my workshop to make an new downpipe since mine has been sold..

but if some swede have an car that wants an 3" downpipe and are willing to take the car down here i would gladly do it.

[adamw]

have u sold your rs2?!

[lind4hl]

no, but my DP.. the car has no engine in and no oem exhaust manifold turbo etc etc. so i cant make an weld jig.. i wouls need another s2/ rs2..

[adamw]

would you know where i could find a DP and WG just like the one you made?? or who could make one?

[s2martyn]

i will have 8x 3" downpipes made from s/s by the end of next week,we have just finished the prototype..
they are for stock location turbo,s2/rs2,coupe/avant and will have the option for a flexi joint if you wish...they all have 3 lambda/oxygen/egt sensor fittings in them 2 being in the header 1 in the lower section,these can be supplyed with bungs if you do not need all 3..
also available with v band etc
units can be custom made also..please pm if any interest

[lind4hl]

martyn:

304 or 314ss??

[adamw]

@martin. pm sent

[europeanme]

I am hoping to get a 3" DP/system quoted for by next weekend...I will share my results when I get them...

[adamw]

ok thanks. i just got a quote of £207 for 3m of 3", 1 90 elbow and 2 45 elbows?

[sjw185]

ok thanks. i just got a quote of £207 for 3m of 3", 1 90 elbow and 2 45 elbows?

Is that just material quote or fitted to boxes etc? seems a bit steep?
Was looking at the Jetex site:

http://www.jetex.co.uk/website/custo...s&dia=3.0+inch

Ive got a scorpion system "middle and backbox" that I want to join up to a 3" downpipe and a 3" pipe to fit to the scorpion middle box doing away with the double pipes and decats etc

cheers

[adamw]

just material! i was looking on www.solid-fabrication.co.uk and thay were quoted me £110 ish

[adamw]

whats the best type of s/s to make a DP with? because i heard 304 will crack under the heat? is 316 the best to use?