Can somebody tell me if i have to remove the o-ring and how it looks or can i just use the 70-60 mm reduction straight on?
/Jonas R:
/Jonas R:
-
I used a 63 mm straight silicone hose and left the o-ring in place. It's a b**** to get the straight 63 mm hose to stretch onto the ic, but it can be done. Soaking the hose in hot water makes it slightly more flexible.Markus
'94 Kristallsilber-metallic S2 Avant. -
no need to take the exisiting seal out. i changed it at the same time with a new one and for the sake of 87p for it from the stealers there didnt seem much point in not doing it.
GregGreg
S2Forum.com Administrator & Webmaster
'93 Coupe with a few tweeks
Comment
-
I removed my oring to make fitting much easier. Old one was mashed and I couldn't get a spare in time.1995 S2 Avant with some upgrades
Designun Limited....
Aerospace, Space and Motorsport Design Consultancy and hardware supply.Comment
-
It doesnt need the o ring as the hose is replacing the o ring. But if it will fit back in then fit it, otherwise chuck it in the bin.sigpic
Tom C - www.rcmr.co.uk
Audi UR Quattro
Audi 100 C3 2.0 5 cyl 115ps
Audi S2 - 07k engine project aiming for 800ps
Audi B5 RS4 645ps 911nmComment
-
I also have Mark H mod + O ringRS2 chip by mihnea,PKM short IM, forge dump valve, 3" custom stainless exhaust, 18"X8" Porsche 996 rims, conti contact 245/35 Front 225/40 Rear, QR sport top mount, Powerflex bushes, aloy sub frame bushes, neuspeed 19mm RARB,Hard tranny mount, V8 torsen on RS2Comment
Comment