Sun roof lining removal
Collapse
This is a sticky topic.
X
X
-
-
Not sure why this wasn't stuck but it has been now! Great write up. Any tips on how to cut to fit the material around the rear light hole? Also did you just remove the metal clips and not refit them again?
Cheers!
Davidsigpic
1992 3b S2 CoupeComment
-
Hi, blimey, this was a blast from the past !
All holes were pretty much done the same way - cut diagonally from the middle into the corners (not quite all the way into the corner), then fold the triangle over to the other side & glue.
All metal clips were very gently bent open, cleaned up if needed with a wire brush & bent back again. They are very thin, so just be gentle as with a car that is 20+ years old, there is a good chance they will break !
Good luck !
Comment

Comment