Wishbone Type, Cast or Pressed - Photos here

[Corey]

Corey have you any experience with seam welded subframes, is there a noticeable difference?

Who said anything about subframes?

driven a few cars with them done though and liked how they felt, when compared to stock

[stevieyid]

Can someone tell me wha type i have from the pic. Im looking into polybushes so i need to know what type i have, thanks.

[lind4hl]

they are the small bushings in the front, cast, check rear also

[denniselbows]

that would be a cast type you have there

[stevieyid]

Thanks for the reply, now to look for the best place to get the powerflex bushes any ideas?

[Audi-Porsche Avant RS2]

Hello, so the best are the cast types for S2 Coupe ABY and RS2? What do you think about the complete front and rear Powerflex kit for the RS2? Is true that the RS2 can mount different diameter of anti roll bar if have the comfort pack or not? And S2 Coupe ABY? Thanks a lot!
Alessio

[MattS2]

Thanks for the reply, now to look for the best place to get the powerflex bushes any ideas?

I've just recently bought a set of bushes for my Avant from Larkspeed. (Advertised on ebay)
They were the cheapest I could find online.


Matt.

[Audi-Porsche Avant RS2]

I've just recently bought a set of bushes for my Avant from Larkspeed. (Advertised on ebay)
They were the cheapest I could find online.


Matt.

Are of good quality for you or not? Thanks a lot! Bye

[quicktrick]

cast type control arm for S2 Coupe

My front right control arm is bend (pavement lol) Just the one of the two but not badly though. Obviously now alignment is out. Tried to find replacement new or used but living here in Africa it is basically impossible. Even Audi SA cant be of assistance. Someone is prepared to heat it and make it straight then enforce it with steel into the H-shape. Do I take that chance or not?

[A1quattro]

i would look up audi breakers on the net . there are a few in uk , they will send you the replacment wishbone.

[diesel des]

Are front and rear arms interchangeable?

[campbellWS]

Are front and rear arms interchangeable?

No Des, the rear to front are offset by aprox 1or2 inch, I had a look at this when there was a few kicking about, it would be good to have the three holes at the back eh?? I think Arron (speedingG60) put four cast wishbones on his drag coupe but put them on opposite left to right and upside down, tho the rear wheels were not perfect in the arch

Obviously the typ85 & s2 front wishbones are different with 2&3 holes, can someone confirm the rear wishbones are different?

[diesel des]

I will give it a try ans see what it looks like on s2 running gear in a urq

[campbellWS]

I will give it a try ans see what it looks like on s2 running gear in a urq

sounds good, i am going to go that way with my typ8590 with S2 running gear. dont think that wee bit will make much of a difference

[Tonks4x4]

I have fitted cast arms on the rear of my shorty.