Rear diff mount bush

[Flipman]

Hello!

I am going to replace bush for rear diff mount.
I noticed that the new bush I bought is not centerd like the old
one..

So, what is the right way to press it in?



//Emil

[Flipman]

Have no one replaced this one?
and knows how it shold be?

/Emil

[Tony Stark]

I replaced mine with the same bush pictured. The knackered one removed had a centered hole.

The subframe bolt hole was like a long kidney slot and i pressed it in as per the bottom right picture.

Would be good to get some more answers on it.

[Flipman]

Thanks!

Have totally missed that you can adjust on the subframe!
made it a alot easier..

/Emil

I replaced mine with the same bush pictured. The knackered one removed had a centered hole.

The subframe bolt hole was like a long kidney slot and i pressed it in as per the bottom right picture.

Would be good to get some more answers on it.

[Colesy]

About to get one of these pressed in this afternoon, is the bottom right picture the correct orientation?

[Mikes2]

Bottom left normally.

There should be an arrow on the bush indicating direction of travel

[Error404]

Will do you have the part number for the new bush? I need one

[Colesy]

Bottom left normally.

There should be an arrow on the bush indicating direction of travel

Great, cheers for the info, there is an arrow on the bush as per the pics above so sorted. Thanks.

I have a Febi Bilstein bush Alex, Part no. 06879.

[Error404]

Sweet cheers mate ��

[_ShurikeN]

Febi Bilstein bush Part no. 06879

Waste of time, it's too weak. Lasted one vacation in small mountains on my car.

[_ShurikeN]

I liked this better: Nissan 54476-10V02 (or replacements). It contingently fits coupe diff. Some mods needed.

[gmac78]

I'm looking to replace this bush again as went from a Febi, which like you say is just to soft, to a powerflex which i'm not liking due to the increased vibration. Whats mods are needed to the Nissan one? Cheers

[Error404]

Needs a sleeve putting in I believe. I have one here but not got around to it yet

[gmac78]

Hey. A sleeve between the bolt and the inner bonded bush? I wonder has anyone drilled more holes in the powerflex bush to soften it up a bit. Might try that to see how it works out.

[_ShurikeN]

Whats mods are needed to the Nissan one?

Diameters difference is very small. I put a small drop of welding onto the bushing sleeve so that it would fit tight into the mount.