Ok will show my project.Car is Audi S2 coupe 1995/12 ABY laser red.I bought this car for drag race and some track days.Target is make 10s car with over 600 bhp.With standard engine I did 12.81s in santapod.With same engine but on vems I did 12.69s and that run broke cj joint.Now engine is modified so this is mod list:
Pistons original modified with new rings
Scat rods
ARP head studs
Head ported
Ferrera 6000 titanium valves
Stronger valves springs
Titanium valve spring retainer
7A cams
Engine full balanced
Clutch:7A flyweel (lighted and balanced), kevlar disc from clutchnet,sach race pressureplate.
Solid engine and gerbox mounts made by my
Vems ecu by Kamuto
Turbo Holset H1E (40) T3 flange V-band and is stamped 12 in Exhaust side.
Tail 44 copy wg
Boch 040 pump in original tank
Siemens deka 835 (3bar) injectors
Intake aan
Very big IC with 3" piping
This is some foto:
And today I start first time my car after engine all this mods.
Pistons original modified with new rings
Scat rods
ARP head studs
Head ported
Ferrera 6000 titanium valves
Stronger valves springs
Titanium valve spring retainer
7A cams
Engine full balanced
Clutch:7A flyweel (lighted and balanced), kevlar disc from clutchnet,sach race pressureplate.
Solid engine and gerbox mounts made by my
Vems ecu by Kamuto
Turbo Holset H1E (40) T3 flange V-band and is stamped 12 in Exhaust side.
Tail 44 copy wg
Boch 040 pump in original tank
Siemens deka 835 (3bar) injectors
Intake aan
Very big IC with 3" piping
This is some foto:
And today I start first time my car after engine all this mods.
Comment