Carbondesign RS2 lower door trims

[rustybullethole]

Hi , sent you a message ref the grill rings , would not let me post on the advert that i had sent you a message

Have responded by PM

[bright blue]

Have responded by PM

Thanks , email sent over to you

[npvpositive]

These door trims are really becoming a problem. I need to replace two of mine, or at the very least glue in new metal channels and do the best I can with the appearance of the trim. So far I've struggled to find a local fabricator who will make up a couple of channels . . . it's just the sort of small crappy job that none of them want to take on. In fact, one guy offered to do it for A$1,500 . . . that's about £800!!

I'm getting so desperate that I've been looking at furniture drawer runners to see if any might do the job.

Any brilliant ideas gents?!

[Tractor Dave]

Why not make some youself? Buy some aluminium plate 1mm thick. Cut to size and make a former with timber. It's very easy to fold and work with. If you were down the road, I'd give you a hand

[Jiri]

kinaputt any progresses with the prototype?

[kinaputt]

kinaputt any progresses with the prototype?

I will make an update next week, I hope.

[kinaputt]

Next week is now ... I have 3D-printed two parts of the design and glued them together, for testing on a RS2.

2020-10-20 22.22.01.jpg

[Jiri]

Well good works need some time. hope the result is good

[kinaputt]

First test fit on a RS2 yesterday.
2020-10-23 17.19.45.jpg

[dhali7376]

Very nice . Well done for persevering

[Jiri]

looks good

[jazzbo]

Looking good, keep up the good work