Wagner Inlet Install Questions

[king]

thanks for asking
thanks for the answers

What are you planning HJ? :mischeif:

[macspring]

Good Reference

thread. Keep it going to cover all points.

Thanks for same.

[Sonic]

Been working on mine this evening also.

Just one question - the kit comes with a step-up hose to fit onto the intercooler inlet, im assuming ill need to cut back the samco and clamp a bit of tubing between the samco and new hose bit?

[s2martyn]

re

i also need a few answrers to my inlet installation
1/what happens to the dipstick tube bolt?
2/does the pcv valve go to the manifold?or can i remove it?
3/will i get any errors not using carbon cannister?

does anyone have any install pics?
thanks martyn

[Henkjan]

thanks for asking
thanks for the answers

[Jamo]

Cheers, I wanted this on the forum as I could have easily got the answers offline

[Lupo911]

And on an ABY?

same Bolt

[Sonic]

6mm Ground Wire goes on the 6mm Bolt of the 3b Distributor Cap

And on an ABY?

[Lupo911]

For those that have already installed a Reverse IM

a) Where did you ground the wires that were on side of the OEM inlet?

b) What core wire did you use to extend the various connectors?

c) What size hose is the it from the carbon cannister to the IM? Is it 8mm?

d) What size are the default tap size for vac nipples?

a) Ground Wires with 8mm on the lower outisde bolt for the IM, 6mm Ground Wire goes on the 6mm Bolt of the 3b Distributor Cap

b) 1.5

C) 8mm

d) M6

[A80Avant]

i definitelly want the cruise!!

[GazzaG60]

mine came fully tapped. i used a rocker cover bolt ot earth one and i think the corner inlet for the other. wire was extended using a spare megasquirt loom i had.

have a good check of the uinjector bores for rough edges etc.

sedn me a pm if you want a pic. ill e-mail you one tomorrow, ill take apic at lunch if you need it.

i am yet to mod the cruise to fit if thats your next q

[A80Avant]

im subscribing on this thread.

im going to need some info there myself.
A friend of mine got me the IM on a good price so i will be probably using it on my next big upgrade!

[Jamo]

For those that have already installed a Reverse IM

a) Where did you ground the wires that were on side of the OEM inlet?

b) What core wire did you use to extend the various connectors?

c) What size hose is the it from the carbon cannister to the IM? Is it 8mm?

d) What size are the default tap size for vac nipples?