Wagner Inlet Install Questions

[s2_bo]

I made a rad bracket out of some drilled 1.5mm steel plate, just cut it to size and it works a treat, one end on the rad the other on the throttle cable bracket.

You can buy a long throttle cable from here:

http://www.cbsonline.co.uk/throttle-cable-long-thcab-932-p.asp

Or just call the AA and get them to put a new cable in for you, that what i did. As long as the sleeve reaches the bracket.

Good lcuk

[QuattroFever]

anyone got any tidy solutions to extending the cable?

Pics of that custom rad bracket plz.

[s2martyn]

i had to make a brace for the rad ,the hose was not good enough...this was due to the fact that i have a second intercooler in front of the rad...you can just see it in the pic..(black bar in front of rad) also a pic of the manifold

[Sonic]

Some Customers letting the Coolant Hoose do that Job, so far didnt heard of any Problems...

Not really had any problems, but i notice the rad rubbing into the coolant hose which might cause a problem later down the line.

How much? I've the same problem been looking at solutions

I'll look into getting one made to fit for mine, can let you know how it goes?

[Lupo911]

How much? I've the same problem been looking at solutions

It was just one off... sorry...

[Jamo]

I made a custom Bracket for the Watercooler to hold it from the Back. No Picture.. sorry.
Some Customers letting the Coolant Hoose do that Job, so far didnt heard of any Problems...

How much? I've the same problem been looking at solutions

[Lupo911]

Ive just thought of a question - the radiator is held in place with a metal bracket between it and the slam panel.

This doesnt fit with the reverse inlet manifold - is there an alternative (e.g. a custom bracket) as apposed to just letting the coolant hose support it?

I made a custom Bracket for the Watercooler to hold it from the Back. No Picture.. sorry.
Some Customers letting the Coolant Hoose do that Job, so far didnt heard of any Problems...

[Sonic]

Ive just thought of a question - the radiator is held in place with a metal bracket between it and the slam panel.

This doesnt fit with the reverse inlet manifold - is there an alternative (e.g. a custom bracket) as apposed to just letting the coolant hose support it?

[Lupo911]

some more

[GazzaG60]

you can have a look at mine martyn when we meet.

mine may not be as clean as sonic's however.

[Sonic]

[Lupo911]

way off topic this one

any pics of the mighty wagner reverse manifold on the car/s??

sure...

[s2martyn]

way off topic this one

any pics of the mighty wagner reverse manifold on the car/s??

[Bram]

Can't you post your GT35 upgrade data in another project thread, so we don't go off-topic regarding Wagner reverse IM install questions? Just my preference

[AUDIS2avant]

lindahl : have used ss manifolds on my cossie for 4 years now, with no problems, but i also use a turbo damper, so dont want to say that ss manifolds are bad, but dont forget to get them stabilised or they WILL crack.

Spec is as written earlyer, compleetly std engine but uprated rods, wagner reverse inlet and i/c kit GT35 on AR.63 ex housing @ 1,5bar