My Audi S2 600Hp+ project 56k warning

[AndersS2]

Top tip! thank for that James.

Did it cause any damage?

[Error404]

nice solution mate - very tidy. don't you need to mill it flush with the cam so the bolt will seat properly?

[terrybullwon]

i also thought the OEM DBR key looked nuts.. i will do the same, thanks for the tip James

I got a shoddy bit of mild steel to lock the gear with, it just collapased

Top tip! thank for that James.

Did it cause any damage?

Lucky i was turning the engine by hand

nice solution mate - very tidy. don't you need to mill it flush with the cam so the bolt will seat properly?

The dowel is sunken into the front bearing of the cam shaft in the pictures its not pushed fully in, so when its bolted it does sit very nicely in there

[terrybullwon]

The car's progression is slow but good.

I have completed the following

*Welded intake track 4" through a hole cut into the drives wing and down to the position of the OEM oil cooler.
*External waste gate pipe
*4" Down pipe is almost finished
*Exhaust is mostly all cut to length and just needs welding up
*Decided to bin the Motronic ECU
*Had made 4" to twin 3" collector for exhaust system

Lots to do but the car will be running by the end of the month if i can keep my work levels low enough.

I need to get all the copper washers for the PAS Pump and some O-rings for the injectors. Does any one know of a good supplier of either?

Also does any one have any old door cards?

Cheers James

[lind4hl]

what am i telling you James?? pictures,pictures!!

[quattro]

Not just me that broken one of these then!

[terrybullwon]

what am i telling you James?? pictures,pictures!!

Sorry mate, No camera at the moment but thanks for the welding tips

Not just me that broken one of these then!

Yeah to be fair i put no effort in at all

[lind4hl]

No problem mate

[terrybullwon]

4" to twin 3"

[Audi_CQ]

4" to twin 3"

Sharp turns. Not good for flow even if size is large enough
Dual 3" is 1000hp size so shouldn't be much backpressure.

[Jonnybravo]

Seen something similar done by Meerkat, 4" into 2 x 3" side exits, looking at the pic it doesn't look as tight as Terrys.

[terrybullwon]

Well I think it should be fine, it will flow enough that's for sure

[Bram]

It looks like a SS tree growing underneath that car

[Jonnybravo]

The blue Focus ?

[Rocco]

COMPLETE AWESOME ALL James


and all in pearl white like me