RS2 "stroker" projekt... 700hp

[Jamo]

Got my 996 callipers yesterday and som brackets from Bruno.
Also baught a (3 ) spanner for the flared nut and bleed nipple

Fitted these onto my car, just to warn you you may have to grind the rear arm where the bracket sits or else the bracket won't line up properly with the bolt holes.

Mine needed about a 1mm removed from each side to get it too sit flush when bolted up

[volcano rs]

Some brackets made for the 6-pot's
The disc is the 322mm 965 351 045 00

As you see its a tight fitt even with the 18".
Are my cup reps extremly small inside or what?





On the new rear callipers the flared nut and bleed nipple came off very easy for the switch.

there seems to be a bit of gap between the disc and the caliper .i.m sure you could get bigger disc under there .

[lind4hl]

Why bigger discs? just adding weight.. im sure those discs he have generates enough stopping power

[smiler]

Looking for pads for my rear callipers...

I have Yellow Pagid P90 for the front that came with the callipers.


Suggestions?


The BrunoBracket seems to work



No time for the project in the summer though...

[A80Avant]

nice upgrade, and keeping the original handbrake, although ******! hmmm

[Jamo]

Looking for pads for my rear callipers...

I have Yellow Pagid P90 for the front that came with the callipers.


Suggestions?


The BrunoBracket seems to work



No time for the project in the summer though...

Yep I have the Bruno bracket on and it works a charm perfect fit

[smiler]

nice upgrade, and keeping the original handbrake, although ******! hmmm

Al the parts are new so it should work out fine for how i will use the car.


No thoughts about the rear pads?
Go for the Pagid there also?

[Jamo]

DS2500, I wouldn't put too an aggressive pad on the rear as they don't heat up as much as the fronts to get them up to temp

[Rusty]

DS2500 up front, DS on the rear. I have DS2500 on the rear and all they do is squeak

[smiler]

Engine home...

[fish]

Have you been to edsbyn to get it? And are you going to the PPF meet today?

[smiler]

Have you been to edsbyn to get it? And are you going to the PPF meet today?

Yey!!

CP-S has built the engine.

Went to the PPF-race before, but it started late because of rain.
Guess you'll have better weather today

[fish]

Had a great day. Nymark from söderhamn run a 9,80 @ 1/4 mile, can´t remember the exit time though... a LOT of quick cars though=)

[smiler]

[smiler]

Had a great day. Nymark from söderhamn run a 9,80 @ 1/4 mile, can´t remember the exit time though... a LOT of quick cars though=)

Yeaa he does 9sec runs on every race with his URQ... good for a car with 630whp