My 3B to RS2 project

[newsh]

Wagner EM and Turbo back on and DP bolted up.
Wagner IM and Throttle Body on and injectors and rail and fuel lines hooked up.
Still have to fit the PS pump, hope it goes on with the IM in situ
Wiring to extend and throttle cable to sort out. The bracket near the TB for the cable looks like its at a strange angle..

[Rocco]

how is it your thorttle body, 65 or 70mm???

[newsh]

how is it your thorttle body, 65 or 70mm???

Stock 3B.

[dkw_dude]

Wagner EM and Turbo back on and DP bolted up.
Wagner IM and Throttle Body on and injectors and rail and fuel lines hooked up.
Still have to fit the PS pump, hope it goes on with the IM in situ
Wiring to extend and throttle cable to sort out. The bracket near the TB for the cable looks like its at a strange angle..

Good work! I think you need a shorter PAS belt? I also bought a Wagner intake for my 3B so I'm paying attention here Will the 3B fuel rail fit the manifold?

[newsh]

The 3B rail is all hooked up and fits perfectly

Yes, I have a few belts in the garage, might be one that fits, if not its down to halfords.

[TimE-J]

Did you have to move the main rad at all with that inlet manifold?

[SE_30]

Great project thread here and good work, have made a few very usefull notes for my project. Keep up the good work.

[newsh]

Did you have to move the main rad at all with that inlet manifold?

No, it should go back in the same place.

[newsh]

Bit more progress tonight, only started at 10 pm

[dkw_dude]

Looking good! Can't be far from startup now!

[newsh]

Looking good! Can't be far from startup now!

It looks a right mess though eh?

Its "interesting" working on it outside at night at this time of the year

[epic]

Don't know if 3B is the same as ABY for the belts.

On my Aby with a Wagner short path intake I have:

Gates Auto Master 6471MC - Belt to Power steering Pump
Gates Micro-V XF 4PK860 - Belt to Alternator.

The 3B rail is all hooked up and fits perfectly

Yes, I have a few belts in the garage, might be one that fits, if not its down to halfords.

[denniselbows]

when i fitted the wagner im on my 3B engined s2 i used a gates 6469mc belt for the power steering belt. its was a bit on the tight side but i've not had any problems. the belt is 13x975mm the next size up is a 6470mc which is 13x1000mm but i think that is the original steering pump belt size for the 3B

[dkw_dude]

According to "Kate" the 3B PAS belt is 992x12,5mm (ABY 12,5x1030mm), think I saw a belt with 990x13mm reccomended at a Norwegian shop which sells Wagner stuff. If that was for ABY or 3B wasn't indicated but I'd guess 3B.

[newsh]

Cheers chaps, good info.