Kessu what cam are you using? you also use springs and retainers or just the cam? thanks
Announcement
Collapse
No announcement yet.
Audi b2 coupe quattro 10vt vems
Collapse
X
-
Kessu what boost pressure are you running for that power. I also bought a 283 / 274° cam from catcams and i am in the process of rebuilding the engine. Thanks alot.Last edited by bn-01-wso; 11 April 2014, 15:19.
Comment
-
I finally managed to rebuild the engine and get it maped by Kulinpapa one of the best Vems tuners. Is working on 1.5bar pressure. I am curious about the power output but i don't have a dyno in my area.Last edited by bn-01-wso; 24 July 2014, 15:09.
Comment
-
-
Received my new clutch today after 2 months. Can't wait to mount it and see how it launches with the 01E gearbox. I had some trouble with 016, i couldn't lock the center diff and looked like i had FWDAttached Files- 11823766_1002094333156274_1059092174_n.jpg (72.9 KB, 47 views)
- 11824263_1002100073155700_2070370968_n.jpg (79.6 KB, 40 views)
- 11830167_1002100029822371_1467009586_n.jpg (56.5 KB, 38 views)
- 11853877_1002100046489036_1846200814_n.jpg (55.3 KB, 37 views)
- 11846219_1002100089822365_400265653_n.jpg (62.8 KB, 44 views)
Comment
-
Originally posted by diesel des View PostWho made the clutch? Is that a custom flywheel too? Nice project .
Clutch was made in Hungary with new custom flywheel. It is a reconditioned 2 disk Tilton. I am waiting to see how hard it will to drive it. Never been to gym before so no leg days
Comment
-
It should grip hard! May not be as hard to push as you think. I'm trying to get an organic 2 plate clutch made for my urs4 to make city driving easier than a single sintered Sachs unit. Could you measure from flywheel face to pressure plate point were the release bearing touches for me please. I am wondering what the stack height is.
Comment
-
Originally posted by diesel des View PostIt should grip hard! May not be as hard to push as you think. I'm trying to get an organic 2 plate clutch made for my urs4 to make city driving easier than a single sintered Sachs unit. Could you measure from flywheel face to pressure plate point were the release bearing touches for me please. I am wondering what the stack height is.
Comment
Comment